Instruction Manual

134 - User EXEC Mode RocketLinx ES8509-XT User Guide: 2000557 Rev. C
Configuration Using the Command Line Interface (CLI)
User EXEC Mode
When you login to the ES8509-XT with the CLI, you are in User EXEC mode.
In User EXEC mode, you
can ping, telnet to a remote
device, and show some basic
information.
Type the command and
press Enter:
• enable to access
Privileged EXEC mode
(Privileged EXEC Mode
on Page 136).
• exit to logout.
• ? to see the command
list.
• list to review the User EXEC mode commands and corresponding options.
For the complete list of commands with options, refer to User EXEC Mode
on Page 185.
Accessing the Options for a Command
The following example illustrates how to view the description and options for a command. This example
illustrates the show command and the firmware version displayed may not reflect your firmware version.
Note: The ? does not appear on the screen.
1. If you type show? (without a space between show and the ?; do not press the Enter key) the ES8509-XT
provides a basic description of that command.
2. If you type show ? (with a space between show and the ?; do not press the Enter key) the ES8509-XT
provides information about the options for that command.
3. Type show ip ? (with a space between show and the ?, do not press the Enter key) to review the options for
ip.
Switch>
enable Turn on privileged mode command
exit Exit current mode and down to previous mode
list Print command list
ping Send echo messages
quit Exit current mode and down to previous mode
show Show running system information
telnet Open a telnet connection
traceroute Trace route to destination
Switch login: admin
Password:
Switch (version 2.7 -20130314 - 15:23:41)
switch> show
show Show running system information
Switch> show
arp ARP table
gvrp GARP VLAN Registration Protocol
ip IP information
version Displays ISS version
Switch> show
Switch> show ip
forwarding IP forwarding status
route IP routing table