Instruction Manual

150 - Port Configuration (CLI) RocketLinx ES8509-XT User Guide: 2000557 Rev. C
Configuration Using the Command Line Interface (CLI)
Rate Control
Rate Control
– Ingress or
Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.
Rate Control
– Filter
Packet Type
Switch(config-if)# rate-limit ingress mode
all Limit all frames
broadcast Limit Broadcast frames
flooded-unicast Limit Broadcast, Multicast and flooded unicast frames
multicast Limit Broadcast and Multicast frames
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Port Trunking
Display –
LACP
Switch# show lacp internal
LACP group 1 is inactive
LACP group 2 is inactive
LACP group 3 is inactive
LACP group 4 is inactive
LACP group 5 is inactive
Display –
Trunk
Switch# show trunk group 1
FLAGS: I -> Individual P -> In channel
D -> Port Down
Trunk Group
TGID Protocol Ports
-----+---------+------------------------------------------------
1 Static 1(D) 2(D)
Switch#