User Guide Owner manual

118 - Port Statistics RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G
Configuration Using the Web Interface
Port Statistics
Use this page to view operation statistics for each port. The statistics that can be viewed include Link Type,
Link State, Rx Good, Rx Bad, Rx Abort, Tx Good, Tx Bad and Collisions.
Note: If you see an increase of Bad, Abort or Collision counts, that may mean the network cable is not properly
connected or the network performance of the port is poor. Check your network cable, the network
interface card of the connected device, the network application, or reallocate the network traffic.
The following information provides a view of the current port statistic information.
Port Statistics Page
Type Indicates the port type.
Link Indicates the link status; Up or Down.
State Indicates the link state; Enable or Disable.
RX Good
The count of good frames received, which is the total number of
received unicast, broadcast, multicast, and pause frames.
RX Bad
The count of bad frames received, which is the total number of
undersize, fragment, oversize, jabber, receive errors (RxErr), and
frame check sequence errors (FCSErr) frames.
RX Abort
The count of abort frames received, which is the total number of
discarded and filtered frames.
TX Good
The count of good frames transmitted, which is the total number of
transmitted unicast, broadcast, multicast and pause frames.
TX Bad The count of FCSErr frames transmitted.
Collision
The count of collision frames, including single, multiple, excessive,
and late collisions frames.
Clear Selected Click to clear selected port counts.
Clear All Click to clear all counts.
Reload Click to reload all counts.