User Guide Owner manual

RocketLinx ES9528 and ES9528-XT User Guide: 2000508 Rev. G Monitor and Diag (CLI) - 179
Configuration Using the Command Line Interface (CLI)
MAC Address Table (continued)
Show MAC
Address Table
– Static MAC
addresses
Switch# show mac-address-table static
Destination Address Address Type Vlan Destination Port
------------------- --------------- ------- -------------------
00c0.4e33.0101 Static 1 fa4
00c0.4e33.0102 Static 1 fa5
Show Aging
timeout time
Switch# show mac-address-table aging-time
the mac-address-table aging-time is 300 sec.
Port Statistics
Port Statistics
Switch# show rmon statistics fa4 (select interface)
Interface fastethernet4 is enable connected, which has
Inbound:
Good Octets: 178792, Bad Octets: 0
Unicast: 598, Broadcast: 1764, Multicast: 160
Pause: 0, Undersize: 0, Fragments: 0
Oversize: 0, Jabbers: 0, Discards: 0
Filtered: 0, RxError: 0, FCSError: 0
Outbound:
Good Octets: 330500
Unicast: 602, Broadcast: 1, Multicast: 2261
Pause: 0, Deferred: 0, Collisions: 0
SingleCollision: 0, MultipleCollision: 0
ExcessiveCollision: 0, LateCollision: 0
Filtered: 0, FCSError: 0
Number of frames received and transmitted with a length of:
64: 2388, 65to127: 142, 128to255: 11
256to511: 64, 512to1023: 10, 1024toMaxSize: 42
Port Mirroring
Enable Port
Mirror
Switch(config)# mirror en
Mirror set enable ok.
Disable Port
Mirror
Switch(config)# mirror disable
Mirror set disable ok.
Select Source
Port
Switch(config)# mirror source fa1-2
both Received and transmitted traffic
rx Received traffic
tx Transmitted traffic
Switch(config)# mirror source fa1-2 both
Mirror source fa1-2 both set ok.
Note: Select source port list and TX/RX/Both mode.
Select
Destination
Port
Switch(config)# mirror destination fa6
Mirror destination 6 set ok