User guide

10 - Hardware Installation DeviceMaster FreeWire Installation and User Guide: 2000412 Rev. D
Factory Default Settings
Factory Default Settings
The DeviceMaster FreeWire is shipped with a default configuration that works
with the most common serial-to-Ethernet and wireless connections. The default
settings can be changed to suit specific installation requirements using the
FreeWire Manager, embedded web server page, or a Telnet connection to the
DeviceMaster FreeWire internal console.
The factory default settings can be easily restored at any time by performing a
cold reset (press and hold the Reset button on the device for more than five
seconds).
The following table lists the DeviceMaster FreeWire default settings.
Parameter Description Settings
Character bits per character 8
Flow flow control None
Parity parity None
Baud rate bits per second 115,200
Stop stop bits per character 1
Mode line mode (serial port protocol) 232
ECABLE E-Cable mode (for TCP connections) Disable
ECADDR E-Cable destination IP address (set by user)
ECONN E-Cable connection attempt time 20 seconds
ECPORT E-Cable destination IP port number 9100 (raw data)
Web browser password (not case-sensitive) access
Network
settings
IP address
Subnet mask
Default Gateway
192.168.250.250
255.255.0.0
0.0.0.0
Protocols DHCP, static addressing, arp, rasp, and BootP protocols