User guide

DeviceMaster FreeWire Installation and User Guide: 2000412 Rev. D Configuring the DeviceMaster FreeWire - 17

Using the DeviceMaster FreeWire Installation Wizard

The DeviceMaster FreeWire default address is 192.168.250.250. It may be

necessary to change the IP address on your host system temporarily to program

the IP address into the DeviceMaster FreeWire. For example: The network

segment must be 192.168.250.x to program the DeviceMaster FreeWire IP address

for your network.

Use this procedure to configure the DeviceMaster FreeWire.

1. If you have not so, install the DeviceMaster FreeWire Installation Setup (Page

14).

2. If necessary, start the DeviceMaster FreeWire Installation Wizard using the

desktop shortcut or Start/Programs/Comtrol/FreeWire/FreeWire Installation

Wizard.

3. Highlight the DeviceMaster FreeWire that you want to configure and click

Continue.

If the DeviceMaster FreeWire that you want to configure does not appear in

the list, click Rescan.

Note: If you have not done so, you must change the IP address on your host to

192.168.250.x so that the DeviceMaster FreeWire Installation Wizard

can communicate with the DeviceMaster FreeWire.