User guide

DeviceMaster FreeWire Installation and User Guide: 2000412 Rev. D Configuring the DeviceMaster FreeWire - 23
Using the DeviceMaster FreeWire Installation Wizard
d. If the COM selection is valid, a green check mark appears next to the Run
Test button.
e. Click Next.
8. If you have not do so, you may want to click Run Test to verify that valid
configuration setting have been selected. If you have tested each configuration
step, it is not necessary to retest the DeviceMaster FreeWire.
9. Click Finish to complete the first phase of the configuration process.
10. In some cases, you may need to perform more configuration procedures:
• To configure serial port characteristics, go to Advanced Serial Port
Configuration on Page 24
• To configure Ad Hoc wireless settings, go to Configuring Ad Hoc Mode
on
Page 25