Owner's manual

DeviceMaster Rackmount Shelf Kit Installation 3
DeviceMaster Installation
Use this procedure to install the Rackmount Shelf kit on a 4- or 8-port DeviceMaster.
Make sure that you have reviewed the Installation Guidelines before installing the Rackmount Shelf
kit.
1. Attach the brackets shipped with the DeviceMaster to the bottom of the unit using the screws.
2. Place the DeviceMaster on the shelf, making sure to align the bracket holes on the DeviceMaster
with the DeviceMaster mounting holes illustrated.
3. Insert the flat head phillips screw from the underside of the shelf and secure the four nuts using a
5/16” nut driver. Make sure that the washers on the nuts are facing the DeviceMaster bracket.
If necessary, use a phillips screw driver to hold the screws in place while securing the nuts.
4. Align the power supply bracket (5801097 or 5801804, depending on the power supply) with the threaded
stub and lip, and slide it into place.
Technical Support
If you need technical support, contact Comtrol using one of the following methods.
Contact Method Corporate Headquarters
Downloads http://www.comtrol.com/pub/en/Support
Web site http://www.comtrol.com
Phone [phone]
DeviceMaster
(Bottom)
The bracket can be mounted on either side.
Cable tie