User guide

Operation TrueBlend™
108 Edition: February 2008
7.19.5 Settings
Settings
Î In the loader “status” and “setup”
screens press
to open the settings
screen to configure the hopper loaders
and conveying.
Setting type of hopper loader
Î Press "Hopper Loader" on the "Settings"
screen.
Î Input the name and type volume in cubic
feet of hopper loader.
The appropriate loading and discharge times
are preset depending on the type selection.
(They can be changed at any time).
Type loading discharge
(volume) time [s] time [s]
0.15 4 5
0.50 10 10
1.00 15 10
1.80 20 10
3.00 30 15
Sharing Conveying Pumps
If you are using only one blender and one pump, the default settings for the
wait list (WCN and LCO) should be adequate.
The Trueblend blender also has the ability to share conveying blowers between
blenders. This enables you to have one conveying blower that services multiple
blenders. This function requires that the blenders be networked together in an
ethernet network. If only two blenders are networked together, the blenders
may be connected directly together with a “crossover” style ethernet cable run
between the two receptacles located on the bottom of the control enclosure. If
more than two blenders are to be tied together, the blenders should be