User guide

Installation l 3-5

Installation (continued)

Compressed Air Connections

Connect a compressed air line (80-100 psi) to the inlet of the solenoid valve which

is located on the mounting plate of the filter chamber. An air line is connected

from the solenoid to the vacuum breaker valve within the filter chamber. If the

automatic unload/reload section is used, a line will also be ran to the solenoid

valve mounted on the outside of the reload control. Compressed air must be fil-

tered free of moisture. Automatic unload/reload units come equipped with com-

pressed air filters.

DO NO

T connect compressed air to the 0.75 in. {19.05 mm} solenoid air vent

located on the bottom section of the automatic unload/reload dust collector.

Electrical Connections

Proper operation of the dust collector depends upon its internal vacuum valve

opening whenever the vacuum pump is energized. Electrical connections are pro-

vided by a 3-conductor cable connected to the dust collector. This cable should be

connected to the vacuum pump control enclosure to provide simultaneous opera-

tion of the dust collector when the pump is activated. On automatic unload/reload

dust collectors, the cable is attached to the reload control enclosure, which distrib-

utes power to the various solenoids for the auto reload function of the dust collec-

tor.

Installation

IMPORTANT: Always refer to the wiring diagrams that came with your equipment

to locate specific electrical components. Illustrations and photographs in the User

Guide are intended only to be representative only.