Thermostat User Manual

CAUTION: Always disconnect

and lock out the main power

sources before making electrical

connections. Electrical connec-

tions should be made only by

qualified personnel.

CAUTION: Check the discon-

nect with a volt meter to insure

that the power is off.

Installation l 3-5

Location and Mounting of the HTC

Heater Assembly Models HTC 30,

60 and 90

CAUTION:You are responsible for the structural integrity of this installation.

Note: The HTC heater assembly is shipped mounted to the back of the floor stand on

Models 30, 60 and 90 (see Figure to the right).

The heater is prewired to the control box on HTC Models 30, 60, and 90.

Location and Mounting of the HTC

Heater Assembly Model HTC 120

CAUTION:You are responsible for the structural integrity of this installation.

1 Securely bolt the HTC heater assembly to the back of the floor stand (see

figure to the right). Use the locking fasteners provided to securely mount the

heater assembly to the floor stand to prevent vibration induced loosening.

The heater is prewired to the control box

on HTC Model 120.

Location and Mounting of the HTC

Heater Assembly Models HTC 180

and 270

CAUTION:You are responsible for the structural integrity of this installation.

1 Securely bolt the HTC heater assembly to the back of the floor stand (see

figure to the right). Use the locking fasteners provided to securely mount the

heater assembly to the floor stand to prevent vibration induced loosening.

2 Refer to the wiring diagram to make the wiring connections for the heater

and control box. Also, see page 3-8, “Connecting the Power.” Only a quali-

ied electrician should make the wiring connections between the control and the

heater. The customer must supply the appropriately sized wire and conduit to

make connections.

✐

HTC Heater

IMPORTANT: Always refer to

the wiring diagrams that came

with your heater before making

electrical connections.

Description