Product Manual

Concentric International
1901 Bell Ave., Suite 18, Des Moines, IA 50315
www.concentricintl.com
Rev. 20181228
Page 2 of 13
LA Dual Control
Each Kit Contains the Following Components:
• (1) Control Unit
• (1) Control unit wire harness
• (1) Wired 3-button switch
• (1) 3-button switch wire harness
• (1) Double-sided tape
• (1) Mounting hardware
Optional Accessories:
• 10’ Linear actuator cable extension harness (part no: LA-EXTHARN)
• Linear actuators 2”, 4”, 6”, 8”, 10”, 12” (actuator must have a potentiometer)
Explanation / Overview:
This unit can control 1 or 2 actuators – individually, in sequence, or simultaneously. Each
actuator can have up to 3 user defined presets that are easily programmed via the wired 3-
button switch. This allows you to preset up to 3 different repeatable stops in the actuator
travel for each actuator. With the selection switch on the control unit in the correct
associated position, by momentarily pressing the corresponding button on the wired 3-button
switch or using your own push button switches with the optional input wires (wires included),
you can extend the actuators to the desired preset stop points.
Operations / Programming:
To manually control or program presets for a single actuator, move the selector switch to
position 1 (for actuator 1) or position 3 (for actuator 2) – depending on which actuator you
want to work with. The picture below shows the selector switch in position 1 for actuator 1.
Presets for actuators 1 and 2 are set separately (up to 3 presets per actuator). Additional
information on the function of the 3 position slide switch is in the sections below on how to
program and run in different modes.
3 Position
Slide
Switch
DIP Switches