Linear Actuator Controller LA-Controller Installation Manual & Operation Instructions
Each Kit Contains the Following Components: Explanation: This unit features 3 user programmable presets that are easily accessed via the push-button display to precisely control one linear actuator. Linear Actuators can be used to open trunks, hoods, etc. When the linear actuator reaches a position which you would like to preset, simply press and hold the corresponding button for 5 seconds. The position is programmed by the main control unit and visually indicated by a flashing LED above the preset.
Operating/Programming To extend and retract the actuator: 1-Press buttons 2 and 3 to extend actuator 2-Press buttons 1 and 2 to retract actuator To program presets #1, 2, and 3: 3-Move the actuator to a chosen position 4-Press and hold the #1, 2, or 3 button for 5 seconds -The LED will flash to indicate the preset has been programmed 5-Repeat steps 3 and 4 twice for three different presets ***The presets can be at any position throughout the stroke of the actuator.
Auxiliary Inputs This unit has three negative auxiliary inputs that can be used in conjunction with keyless entry, alarm systems, shaved door kits, etc. When a negative pulse is applied to any of these wires, the actuator will go to the specified preset. **Optional inputs cannot set preset positions, or manually move the actuators. You WILL have to use the display panel to configure the preset locations, at which point you may remove the display.