Product Manual

TYPICAL WIRING
Vehicle Door Locking Circuit
Channels 1 and 2 Using Optional Door Lock Solenoids
Page 9
Basic Functions Of The Remote Control
Remote Control Operation
Channel 1: Onboard relay
Channel 2: Onboard relay
Channel 3:
Channel 4:
Channel 5:
Channel 6:
Channel 7:
The remote control supplied with your kit has four buttons, but is capa-
ble of controlling 7 Channels.
Optional negative outputs (500 mA)
**Additional relays are required for each channel**
To Operate: Press:
Channel 1 Button 1
Channel 2 Button 2
Channel 3 Button 3
Channel 4 Button 4
Channel 5 Button 1 + Button 2
Channel 6 Button 1 + Button 3
Channel 7 Button 1 + Button 4
Remote Control Programming
Reprogramming the Remote Transmitters:
The remote transmitters are shipped Pre-Programmed. In the event that
a remote transmitter loses the programmed code, or if you wish to add
more remote transmitters, follow these steps:
• Make sure ignition is OFF.
• Locate the programming button located on the side of the receiver
next to the LED.
• Press the programming button 3 times quickly (the LED will light).
• Press Button (1) on each transmitter you want learned in to the re-
ceiver (one at a time). There is a 10 second window to learn all new
transmitters.
• The LED will remain lit for approximately 10 seconds after the last
been recognized.
• Wait for the LED to go out. Then test each transmitter for proper
function.
Page 2