System information

P17
Step1: In Picture 3.10, the Direction key will turn PTZ to designated location , click Settings
button to enter Picture 3.13,
Step 2: click Cruise buttons, the write proper value into the Cruise Line and Preset Points blank，
then click Add Preset Points button, complete setting (also can add and delete cruise line which has
been set up)
Step 3: repeat step1 and step2 , until set out all the preset designated cruise lines。
Remove Preset：Please input preset value in the blank, click Remove Preset button, then
remove the preset points.
Remove Cruise Line：Input the number of cruise line, click Remove Cruise Lines button, then
remove the cruise lines set。
Picture 3.13 Cruise Between Points Settings
2）The Calls of Cruise between Points
In Picture 3.10, click Page Shift button, enter PTZ control menu as shown in Picture 3.12. Please
input the number of cruise in the value blank, then click Cruise between Points button, PTZ begins to
work on the cruise line. Click Stop button to stop cruise.
3、Scan
PTZ also can work on the preset scan line repeatedly.
1）Scan setup
Setting steps:
Step1: In Picture 3.10, click Setup button ，enter Picture 3.14；
Step2: Click Scan button，the input proper value in the scan value blank;
Step3: Click Start button, enter Picture3.10 ， here you can set the following items:
Zoom,Focus,Aperture,Direction and so on. Click Setup button to go back Picture 3.14
Step4: Click End button to complete setup。Click the right button of the mouse to exit.
Cruise Button
Cruise Line Blank
Preset Points Blank
Time interval