Installation guide

- 16 -
3.3 Configuring the IP Address of the PC
If you are failed to access to the camera, please check the IP address of your
computer. When you connect the camera to your computer directly to proceed
with configuration of the camera, you need to set up the IP addresses to be in
the same segment for the two devices to communicate.
1. On your computer, click Start > Control Panel to open the Control Panel
window.
2. Double-click Network Connection to open the Network Connection window.
3. Right-click Local Area Connection and then click Properties from the
shortcut menu.
4. When the Local Area Connection Properties window appears, select the
General tab.
5. Select Internet Protocol [TCP/IP] and then click Properties to bring up the
Internet Protocol [TCP/IP] Properties window.
6. To configure a fixed IP address that is within the segment of the camera,
select the Use the following IP address option. Then, enter an IP address
into the empty field. The suggested IP address is 192.168.0.x (x is 0~254
except 30), and the suggested Subnet mask is 255.255.255.0.
7. When you are finished, click OK.