Operation Manual

ENGLISH
11
3. Remote Control Installation
A. Insert the 2 included AAA batteries in the Remote Control.
B. Insert the USB Receiver in a free USB port of your computer.
The computer will recognize and install the USB Receiver automatically.
The USB Receiver and the Remote Control are paired by default. After the
installation of the USB Receiver, you can start using the Remote Control.
4. (Re-) Pairing the USB Receiver with your Remote Control
By default, the USB Receiver is programmed on the same frequency as the
Remote Control. When the Remote Control is not working or is interfering
with another device, you can re-pair the USB Receiver with the Remote
Control:
A. Shortly press the Pair button on the USB Receiver, while the USB
Receiver is connected to the computer.
The LED on the USB Receiver will burn continuously for 20 seconds to
indicate pairing mode.
B. Move the Remote Control close to the USB Receiver.
C. Press and hold the Back Button [7] and Info Button [17] for 3
seconds.
The LED on the USB Receiver will blink shortly to indicate a successful
paring.