User manual

ENGLISH
22
7. Basic CM3S operation
• Select the correct input channel on your TV where the unit is connected to. (Composite, SCART or
Component).
Note:
From this point, the manual is based on the fact that your TV is set to the input channel of the
unit. All steps described are related to the operation of the unit.
• Check if the main power switch on the back of the unit is set to ‘I’.
• Turn on the unit with the power button on the front of the unit, or with the ‘Power’ button (1
) on the
remote control.
The unit will turn on and display the menu on your screen.
Note:
The default output signal of the unit is Composite Video. If the unit is turned on and nothing is
shown on your screen, you can press the OUTPUT button on the remote control to switch between
the various outputs of the CM3S (Composite, Component).
Note:
The unit needs to initialize the harddisk when it is turned on. This can take a little while. During
initializing, the message ‘Wait...’ is shown on your screen.
When the harddisk is formatted with 1 partition, it will show the ‘File Library’ on your screen, displaying
the contents of your harddisk.
When the harddisk is formatted with multiple partitions, the unit will show the ‘Device List’ on your
screen with all the present partitions. Use
/ buttons (15) to move the selection, and press the
‘
/Enter’ (24) button to go to the ‘File Library’, showing the contents of the selected partition.
[ Device List ] [ File Library ]
Change the partition:
When the harddisk is formatted with multiple partitions, you can press the ‘Menu’ (38
) button on the
remote control to go to back to the ‘Device List’ and select a different partition.