Operating instructions

Page 5
TURNING ON THE UNIT
1. In standby mode, press and
hold the MEM button for
about 3 seconds until time
format blinks on display.
2. Press the TUNING/
SKIP buttons to set 12
Hour or 24 Hour time format.
3. Press the MEM button,
the Hour blinks.
4. Press the TUNING/
SKIP buttons to set
correct hour.
5. Press the MEM button,
the Minute blinks.
6. Press the TUNING/
SKIP buttons to set
correct minute, and then
press the MEM button to
start the clock.
CLOCK SETTING
TO TURN ON THE UNIT
Press the POWER ON/OFF button, the POWER
ON indicator will light up. Select the desired
function and the corresponding function indicator
will light up.
TO TURN OFF THE UNIT
Press the POWER ON/OFF button to STANDBY,
the POWER ON indicator will turn off and the
clock display will be shown.
TO ADJUST VOLUME TO ADJUST TONE AND BALANCE
Turn the knobs to adjust the tone output and
speaker balance control to L or R.
ADJUSTING THE SOUND
TO SELECT X-BASS (for remote only)
X-BASS is designed specifically to boost the
low frequency sound to obtain a more powerful
bass.
Note: Press the X-BASS button, the indicator of
X-BASS will light up.
Note:
Your unit is factory preset in 12 hour display.
However, if there is a power failure or the unit
has not been connected to power for a long
period of time, the display may shift to 24 hour.