SDS

Titanium Dioxide
ACGIH TLV (United States, 3/2015).
TWA: 10 mg/m³ 8 hours.
OSHA PEL (United States, 2/2013).
TWA: 15 mg/m³ 8 hours. Form: Total dust
Ethylene Glycol
ACGIH TLV (United States, 3/2015).
C: 100 mg/m³ Form: Aerosol
Cristobalite
OSHA PEL Z3 (United States, 2/2013).
TWA: 250 MPPCF / 2 x (%SiO2+5) 8 hours.
Form: Respirable
TWA: 10 MG/M3 / 2 x (%SiO2+2) 8 hours.
Form: Respirable
TWA: 30 MG/M3 / 2 x (%SiO2+2) 8 hours.
Form: Total dust
ACGIH TLV (United States, 3/2015).
TWA: 0.025 mg/m³ 8 hours. Form:
Respirable fraction
NIOSH REL (United States, 10/2013).
TWA: 0.05 mg/m³ 10 hours. Form: respirable
dust
crystalline silica, respirable powder
OSHA PEL Z3 (United States, 2/2013).
TWA: 250 MPPCF / (%SiO2+5) 8 hours.
Form: Respirable
TWA: 10 MG/M3 / (%SiO2+2) 8 hours. Form:
Respirable
ACGIH TLV (United States, 3/2015).
TWA: 0.025 mg/m³ 8 hours. Form:
Respirable fraction
NIOSH REL (United States, 10/2013).
TWA: 0.05 mg/m³ 10 hours. Form: respirable
dust
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: safety glasses with side-
shields.
Eye/face protection
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
If user operations generate dust, fumes, gas, vapor or mist, use process enclosures,
local exhaust ventilation or other engineering controls to keep worker exposure to
airborne contaminants below any recommended or statutory limits.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Control parameters
Individual protection measures
Occupational exposure limits
Skin protection
Date of issue/Date of revision
:
4/28/2016
Date of previous issue
:
3/27/2016
Version
:
2.02
5/11