Instructions / Assembly

6
Fig. 7-1
Attach the wire
to the GROUND
wire in the junction box.
The GROUND wire is usually a bare copper
wire without plastic insulation. It could also be
covered in green plastic insulation.
Attach the wire and wire from
the ceiling fan to the BLACK
wire in the junc-
tion box.
Attach the wire from the ceiling fan to
the WHITE
wire in the junction box.
To operate your ceiling fan with the pull chain(s)
and switches mounted on your fan, follow the
instruction below (see figure 7-1)
Each of the above connections
should be made as tight as pos-
sible using the proper size plas-
tic wire nuts. Plastic electrical
tape is not recommended for
these connections.
Step 3 Making the electrical connections
(connected to the half
ball)
GREEN
BLACK
WHITE
BLUE
Fold the connected wire and push
them up inside the electrical junction box with
the BLACK and BLUE wires to one side and the
WHITE and GREEN to the other side. Make
sure the wire nuts do not come loose during this
operation.
(see figure 7-2)
Fig. 7-2
Green
White
Black
Blue
Green
White
Black
Blue
If you are going to use an PD-004 Control Unit
with this fan, refer to the Installation Manual
for the PD-004 before proceeding further.