Instructions / Assembly

6
Fig. 6
Blade
Screw
Blade Arm
Washer
Fig. 7
Fig. 8
Mounting Plate
Motor
Housing
Screw
Motor Assembly
Motor Housing
Motor Housing
Pre-Installed
Screws to
Blade Arm
Step 3 Hanging the Fan Body
Carefully slide Motor Housing over Motor
Assembly (see figure 6) and secure with four (4)
Motor Housing screws.
Step 4 Fan Blade and Blade Arm Assembly
Step 5 Fan Blade Assembly Installation
Attach each blade to the motor face using pre-
installed screws (see figure 8). Take care not to
bend the blade arms during installation. This
will cause your fan to wobble while running.
Try mounting the blades on
opposing sides of the motor
face, This will help keep the
fan more level during blade
installation.
Most CONCORD fans are supplied with a
reversible blade finish. Choose the blade finish
that you prefer and attach as follow:
Attach each fan blade to a blade arm with
three 3/16” x 7.5 mm blade screws and three
3/16” fiber washers (see figure 7). DO NOT
OVER TIGHEN THESE SCREWS.
Screws should be tightened until the washers
are compressed by the screw head. Hold the
Blade Arm decorative side down and place
the blade on top with the flat side of the blade
facing down. Each screw is passed through
the washer and blade and screwed into the
blade arm.