Instructions / Assembly

Double/Triple Burner Instruction Manual
Installing legs:
1. Align legs on the bottom of the frame. Once firmly pushed inside thread screws
into holes and tighten.
2. Repeat process with other legs.
Installing regulator hose:
1. Match the brass port of the regulator hose to the burner orifice and hand tighten.
2. Match the female plastic port to your propane burner and hand tighten.
Use:
1. Turn on your propane tank all the way (make sure it is full)
2. Slowly turn on the regulator hose.
3. Once you hear propane running through the hose, manually light the burner with a
flame torch.
Adjusting Air Inflow Valve:
3. Most of the time the burner will come ready to use with no adjustment to the Air
Inflow Valve necessary.
4. However, if you are getting significant low flame or if the flame goes out after a few
seconds, you can adjust the air flow regulator cap (located in front of the burner head)
accordingly to your desired height and blue flame level.
5. Make sure to have a clear overhead.