Application Guide

Concrobium Mold Control
®
Fogging Instructions
Fogger Operation
Guidelines
Use only Concrobium
Mold Control with your
fogging machine. Do not
apply any liquid that is
hazardous to people,
animals or property when
atomized into small
droplets.
Avoid over-exposure to
fog output. While
Concrobium Mold Control
contains no bleach,
ammonia, alcohol, acids or
VOCs, highly atomized
droplets can be quickly
absorbed by the lungs.
Avoid spending undue
time in the target area until
the fog has dissipated.
Keep an intake air filter
in place during use. This
will help prevent dust and
fog droplets from entering
the unit.
Use only a properly
grounded (earthed) three
pin electric outlet. The
ground wire is an essential
safety feature of this
product. Do not remove
the grounding lug on the
power cord. Do not use an
ungrounded (3”-to-2”) plug
adapter. An extension
cord, if used, must have
a continuous ground
wire leading to earth.
The amperage rating of
an extension cord, if
used, must be greater
than the amperage
shown on the fogger
nameplate label. Do not
chain two extension cords
together.
Application: Concrobium Mold Control® is a 100% non-toxic mold-
fighting solution that eliminates and prevents mold with no harmful
chemicals. A fogger atomizes Concrobium Mold Control into a fine mist
that quickly and evenly coats surfaces. Fogging is ideal for treating and
pre-treating various surfaces:
• Large spaces e.g., entire rooms, basements, cellars
• Hard-to-reach areas e.g., attics, crawlspaces, wall cavities
• New home, building or institution construction sites e.g., framed
house
Fogging Objective: to saturate air with Concrobium Mold Control fog
such that the product spreads throughout the target area and coats
surfaces with a thin, even layer. Using the fogger to spray surfaces
directly from a short distance may lead to over-application, and is not
recommended.
Step
Action
1
Review Table 1 for approximate fogging time and product
required.
2
Remove Fogger power head from tank. Add Concrobium
Mold Control to fogger tank. Fasten clamps to secure power
head.
3
Install intake air filter to help protect motor from intake of
mold spores and moisture. Intake filter installs over the
louvers of rear housing of fogger. Attach the two adhesive
backed hook fasteners to 10 and 2 o’clock positions, anchor
bottom of filter and stretch elastic over housing. Filters can
be cleaned and reused should they become soiled.
4
Remove or cover any room contents that may be damaged if
wetted e.g., furniture, electronics, electrical sources, paper
products. Close windows and doors.
5
Adjust liquid flow rate knob at side of fogger head (Low, Med,
High). The liquid flow rate determines the size of the fog
droplets formed by the machine. A Medium flow rate is
recommended for application of Concrobium Mold Control.
6
Position fogger in space being treated and adjust fogger
head angle as required to ensure appropriate throw of fogged
product. Activate and run fogger according to “Room Fogging
Tips” section on page 2 of this document. Fog target space
according to fogging time recommendations in Table 1.
7
Do not over-apply product on surfaces. Run-off and pooling
is a sign of over-application.