Safety Data Sheets (SDS)

Operating Instructions
The Commander Tri-Jet Fogger is very user-friendly for commercial or residential use. The rst
thing you want to do when you remove the unit from the box is to make sure the power switch
is in the off position (ex.1), and the intake lter is clean and on the rear of the unit (ex.2). This
helps to prevent damage to the motor. After choosing the product you are going to spray, remove
the tank from the unit by releasing the four clamps. Make sure to follow ALL guidelines from the
manufacturer of the product that will be used.
Always wear proper safety equipment when in use. Fill the tank to the desired amount, making
sure not to overll the tank. Reattach the tank to the unit, making sure the rubber gasket is in place
to prevent spillage. Plug into the proper power supply. When you are ready to start fogging turn on
the unit and adjust the ow valve to the desired spray amount, making sure not to over fog which
will cause damage to motor
1
(See side bar for more details about over fogging).
When you are done fogging turn off the unit and unplug from the wall. Empty the tank of any
product that may not have been used, and wash the tank out with fresh water. Fill the tank with
warm fresh water and a little detergent, and reattach the unit. Let it run for a few minutes outside
to ensure there is no product left in the fogger - this will prolong the life of your Commander Tri-Jet
Fogger. Always clean and dry the intake lter after each use. When the unit is clean, place it back
into the box to protect it from damage when not in use.
COMMANDER “TRI-JET” FOGGER
Includes: 1) Tri-Jet Fogger, 1) 1-Gallon Tank with Clamps, 1) Intake Filter
Ex. 2Ex. 1
1
Damage from over fogging occurs when
the chemicals being fogged mixed with air
are sucked back into the intake, or rear, of
the unit. The motor is then exposed to the
chemicals causing damage. The fogger
is designed to only have fresh air being
sucked into the intake of the unit.
A room 10x10 with an 8 ft. celling will
only require 2-3 min of fogging - any
longer may result in over fogging causing
damage to the unit.
The Commander “Tri-Jet” Fogger should only be used with approved chemicals that are
listed for
fogging application. Always follow the chemical manufacturer’s recommendations!
Operator Safety
The operator should always wear proper protective equipment. Always wear gloves and use a measuring cup when you are mixing a product
to be fogged. Always wear eye protection while fogging. After fogging any chemical containing hazardous ingredients, provide complete
ventilation. Various products have safety precautions. Always refer to the Material Safety Data Sheet (MSDS) for specic precautions. Do not
expose to rain, and always store indoors. Do not spray towards open ames.
Warranty
Your new COMMANDER “TRI-JET” FOGGER comes with a full 5-year warranty (continental U.S. only). The warranty covers against any
defect in material and workmanship for 5 years from date of purchase. This warranty does not apply to damage resulting from accidental
damage, alterations to unit, misuse or abuse of fogger. Warranty does not cover damage due to over fogging. For repair or replacement
please return unit back to CREATECH USA Inc. For warranty to become effective, the information below must be supplied by email to
[e-mail] within 30 days of purchase date.
Model 672-110v or 220v