Installation Instructions

34 Mounting and installation work
Procedure
1. Mark the attachment points "A" for the mounting rail at the desired position with the help of a spirit
level. Then, drill holes diameter: 10 mm, depth: 50 mm.
2. Insert the supplied plastic plugs, and x the mounting rail to the wall with the screws and washers
supplied. Before tightening the screws adjust mounting rail horizontally using a spirit level.
3. Unlock the screw of the front panels, then remove the front panels.
4. Hang up the unit onto the mounting rail. Then, x the unit to the mounting rail using the supplied
screws "B".
5. Reattach the front panels and secure it with the screws.
5.3.3 Inspecting the installed unit
Check the following points:
Is the unit installed in the correct place (see chapter 5.3.1)?
Is the supporting surface stable enough?
Is the unit correctly aligned, vertically and horizontally?
Is the unit properly secured (see chapter 5.3.2)?