Operation Manual

19Operating the control software
5.1.1 Operating status indication
The following operation status indications may appear during operation:
Operating status indications Description
The control is initialising.
The Condair RS is in standby mode (no demand present).
The Condair RS performs a cylinder ushing.
The Condair RS is producing steam (humidifying).
The Condair RS checks the function of the level unit.
The Condair RS is connected to a BMS, and the BMS has activated the diagnostic mode.
The Condair RS has been stopped via an external enable contact (remote enable/disable).
The Condair RS is in standby mode and the keep warm function is activated.
The Condair RS is stopped due to a malfunction which prevents further operation. Additionally
"Warning" or "Fault" is displayed in the maintenance and malfunction eld.
5.1.2 Maintenance and malfunction indications
The following maintenance and malfunction indications may appear during operation:
Maintenance and
malfunction indications
Description
No malfunction present. By pressing on the indication eld the service menu can be accessed.
This message appears if the maintenance counter for the large maintenance has elapsed. If the
large maintenance is not carried out, and the maintenance counter is not reset within 7 days,
a corresponding fault message appears.
Carry out the large maintenance, then reset the maintenance counter in the "Service" submenu.
This message appears if the maintenance counter for the small maintenance has elapsed. If the
small maintenance is not carried out, and the maintenance counter is not reset within 7 days,
a corresponding fault message appears.
Carry out the small maintenance, then reset the maintenance counter in the "Service" submenu.
A malfunction with status "Warning" is active. Additionally the status LED lights yellow. De-
pending on the malfunction the Condair RS is either be stopped or stays operable for a certain
period of time.
The Condair RS was stopped due to a malfunction, which prevents further operation. Addition-
ally the status LED lights red.