Operation Manual

23Operating the control software
Operating Tab
– Capacity: Actual total steam capacity of the steam humidier in kg/h or
lb/h.
– Control Mode CH 1/3: Actual set control signal type ("On/Off", "Demand",
"RH P" or "RH PI").
– System Demand A: Actual system demand in %.
– Signal Type Channel 1/3: Actual set signal range for the humidity control
signal.
– Signal Type Channel 2/4: Actual set signal range for the limiter signal.
Note: this menu item appears only, if control mode is set to dual signal mode.
– PS1: Actual pressure at the pump of the reverse osomsis system inlet in
bar.
Note: this menu item appears only, if the Condair RS is connected to a
Condair RO-A reverse osmosis system and if the reverse osmosis system
was activated in the factory menu and the pump is running.
– PS2: Actual RO water pressure in the tank of the reverse osmosis system
in bar.
Note: this menu item appears only, if the Condair RS is connected to a
Condair RO-A reverse osmosis system and if the reverse osmosis system
was activated in the factory menu.
Service Tab
– Operating hours: Total operating hours with humidity demand since initial
commissioning of the system.
– Operating hours A: Operating hours with humidity demand of cylinder A
since initial commissioning.
– Operating hours B: Operating hours with humidity demand of cylinder
B since initial commissioning.
Note: this menu item appears only on double units or the large units with
two steam cylinders.
– Next Service A: Remaining time in hours until the next maintenance of
the steam humidier A must be performed related to 100 % capacity.
– Next Service B: Remaining time in hours until the next maintenance of
the steam humidier B must be performed related to 100 % capacity.
Note: this menu item appears only on double units or the large units with
two steam cylinders.
– Operating Hour RO: Operating hours of the reverse osmosis system
since initial commissioning.
Note: this menu item appears only, if the Condair RS is connected to a
Condair RO-A reverse osmosis system and if the reverse osmosis system
was activated in the factory menu.
– Next Service RO: Remaining time in hours until the next maintenance of
the reverse osmosis system must be performed related to 100 % capacity.
Note: this menu item appears only, if the Condair RS is connected to a
Condair RO-A reverse osmosis system and if the reverse osmosis system
was activated in the factory menu.