Operation Manual

49Operating the control software
5.6.2 Switching on/off password protection and software updates function -
submenu "Administrator"
In the "Administrator" submenu you can activate and deactivate the password protection for the main
menu and the setpoint, and download software updates via a USB stick connected to the USB connector.
Password settings Tab
– Setpoint Password: with the function "Setpoint Password" you can
protect the setpoint input screen with the user password "8808" against
unauthorised access ("Yes") or not ("no").
– Main Menu Password: with the function "Main Menu Password" you
can protect the access to the main menu with the user password "8808"
against unauthorised access ("Yes") or not ("no")
– Software Update: with the function "Software Update" you can update
the control software of the integrated controller. See information in chapter
6.8.
– Driver A.DB.A Update: with the function "Ext.A.DB.A Update" you can
update the driver board software of steam humidier A.See information
in chapter 6.8.
– Driver B.DB.A Update: with the function "Ext.A.DB.A Update" you can
update the driver board software of steam humidier B.See information
in chapter 6.8.
– Driver C.DB.A Update: with the function "Driver C.DB.A Update" you can
update the software of the optional reverse osmosis control board. See
information in chapter 6.8.
Note: this menu item appears only, if the Condair RS is connected to a
Condair RO-A reverse osmosis system and if the reverse osmosis system
was activated in the factory menu.
– Load Contact Info Page: this function allows you to upload new contact
information data (which are displayed when pressing the <Help> button)
from a USB memory stick connected to the USB port on the control board.
– Manually Load Contact Info: this function allows you to manually change/
enter contact information data (which are displayed when pressing the
<Help> button).
– LoadLoggerDenition: this function allows logging of system parameters
with a FAT32 formatted USB memory stick connected to the USB port
on the control board. A factory supplied access le is required to enable
operation.
Software Settings Tab