Operation Manual
50 Maintenance
6 Maintenance
6.1 Important notes on maintenance
Qualicationofpersonnel
All maintenance work must be carried out only by well qualied and trained personnel authorised by the
owner. It is the owner’s responsibility to verify proper qualication of the personnel.
General note
The instructions and details for maintenance work must be followed and upheld.
Only the maintenance work described in this documentation may be carried out.
Only use original Condair spare parts to replace faulty parts.
Safety
Some maintenance work requires removal of the unit covers. Please note the following:
DANGER!
Dangerofelectrichazard!
You may get in touch with live parts when the unit is open. Touching live parts may cause severe injury
or even lethal violation.
Prevention: Before carrying out any maintenance work set the Condair RS out of operation as described
in chapter 4.5 (switch off the unit, disconnect it from the mains and stop the water supply) and secure
the unit against inadvertent power-up.
CAUTION!
The electronic components inside the humidier are very sensitive to electrostatic discharge.
Prevention: Before carrying out any maintenance work to the electrical or electronic equipment of the
humidier, appropriate measures must be taken to protect the respective components against damage
caused by electrostatic discharge (ESD protection).
WARNING!
Danger of burning!
The water in the steam cylinder and in the scale collector tank can be hot (up to 95 °C). There is
danger of burning when the steam cylinder(s) and the scale collector tank(s) is/are dismounted
shortly after steam has been produced.
Prevention: Before carrying out any work on the steam system set the Condair RS out of operation as
described in chapter 4.5, then wait until the components have cooled down sufciently (see temperature
indication adhesive on the scale collector tank) thus preventing danger of burning.