Operation Manual

74 Fault elimination
7.4 Saving fault and service histories to a USB memory stick
The fault and service histories of the Condair RS can be saved to a USB memory stick for logging and
further analysis. For this purpose proceed as follows:
1. Set the On/Off switch on the front side of the steam humidier to the Off position, then switch off the
voltage supply to the steam humidier via the external disconnect switch (electrical isolator) and
secure switch in the off position to prevent it from inadvertent power up.
2. Unlock the door panel on the control compartment side of the steam humidier and remove it.
3. Swing control panel assembly open.
4. Carefully insert FAT32 formatted USB memory stick into the USB port on the control board. Make
sure that the maximum length of the memory stick does exceed 75 mm.
5. Close control panel assembly, then close the door panel of the control compartment and lock it with
the screw.
7. Remove the lock and tag from the external disconnect switch. Then, switch on external disconnect
switch to restore power to the humidier.
7. Set the On/Off switch on the front side of the steam humidier to the On position.
8. When the standard operating display appears, select the <Menu> button, then enter the password
(8808) to login.
9. Select "Service > Fault/Service History Tab > Export History". The last 40 humidier fault and
service history events are then downloaded to the memory stick as separate .csv les labelled
"WARNING_FAULT.csv" and "SERVICE_HISTORY.csv".
Note: the CSV tables can be processed with a spread-sheet program on a PC
10. Repeat steps 1 to 3, then carefully remove the USB memory stick.
11. Close control panel assembly, then close the door panel of the control compartment and lock it with
the screw.
12. Repeat Step 6 and 7 to power up the humidier.
7.5 Resetting the fault indication
To reset the error indication (red LED light, operating status indication shows "Stop"):
1. Switch off the Condair RS via the unit switch.
2. Wait approx. 5 seconds, then switch on the Condair RS again.
Note: If the fault has not been eliminated, the fault indication reappears after a short while.