Owner manual

Comfit Couplers
installation Guide
Condux International, Inc. • 145 Kingswood Drive • PO Box 247 • Mankato, MN 56002-0247
1.800.533.2077 (US & Canada) • 507.387.6576 • Fax: [phone]
www.condux.com• [e-mail]
mountinG instruCtions
Comfit Couplers have a push-lock mechanism which enables them to be installed
on pipes without pre-dismantling.
do not take the coupler apart unless absolutely necessary.
Literature Part Number: 08566199-r2.0
1. Bevel the pipe edge with the Comfit Chamfering Tool.
End of pipe must be clean and round.
Keep inside of coupler free from sand and mud.
2. Mark insertion depth on the pipe.
3. Push the Coupler on the pipe to the mark.
After mounting pull the pipe forcibly by hand to ensure
correct installation.
Mark insertion depth on
the pipe as shown.