USER GUIDE & SAFETY MANUAL Power Dart Blower (220 VAC)
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following: Read and understand all procedure and safety instructions before using a Condux Power Dart ® Blower. Observe all safety information on this page and note specific safety requirements as explained by procedures called out in this manual.
IMPORTANT SAFETY INSTRUCTIONS BEFORE YOU USE THIS PRODUCT Grounding Instructions 1. This 220 Volt Power Dart Blower should be grounded while in use to protect the operator from electric shock. The Power Dart Blower is equipped with a 3-conductor cord. It must be fitted with a 3-prong grounding type plug to fit the proper grounding type receptacle. The green and yellow conductor in the cord is the grounding wire. Never connect the green and yellow wire to a live terminal.
IMPORTANT SAFETY INSTRUCTIONS Outdoor Use Extension Cords 3. If used outdoors, the extension cord must be marked with the suffix W-A following the cord type designation (e.g., STJW-A). 4. Use an extension cord with the proper wire size for the length of the cord. An undersized cord will cause a drop in line voltage, resulting in loss of power and overheating (See Chart below). 5. Position the cord so that it will be clear of any rotating parts and will not be a trip hazard to the operator.
IMPORTANT SAFETY INSTRUCTIONS Keep Children Away 14. Do not let anyone but the operator touch the Power Dart Blower or the extension cord; all visitors should be kept a safe distance away from the work area. Store Idle Tools 15. When not in use, the Power Dart Blower should be stored in a dry, secure area—out of the reach of children. Don't Force Tool 16. Use the Power Dart Blower only for its designed use; do not force the blower to perform beyond its capabilities. Dress Properly 17.
General Information The Condux® Power Dart ® Blower uses three 4 Amp motors to deliver a maximum of 8.5 m3¼min (300 ft3¼min) of forced air. It easily blows poly line or measuring tape over 610 meters (2000 feet) in up to 152 millimeter (6 inch) diameter conduit. The unit requires an electrical outlet rated for at least 12 Amps or a 2700-watt generator. Weighing only 14 kilograms (30 pounds), the unit can be set up anywhere with ease. The complete kit contains 7.
Air Inlet Rear Air Outlet Power Switches Drag Plate Blowline Line Missile Access Hole Air Hose Seal-Off Troubleshooting Guide Problem Possible Causes Missile does not exit at destination • Duct is obstructed • Duct is not airtight • Duct length is too long • Missile is worn or the wrong size • Too much tension on blowline • Too many bends in the conduit Blowline builds up in duct • Drag plate is not properly set • Missile is worn or the wrong size Unit does not turn on • Blown utility fuse—not r
Limited Warranty Condux International, Incorporated extends the following warranty to the original purchaser of these goods for use, subject to the qualifications indicated: Condux International, Incorporated warrants to the original purchaser for use that the goods or any component thereof manufactured by Condux International will be free from defects in workmanship for a period of one year from the date of purchase, provided such goods are installed, maintained, and used in accordance with Condux’s writte
