Installation manual

ENGLISH
Conergy TS
Installation Manual
26
4.14 Gas (AES) Installation Instructions Note
Important note:
|
|
|
|
|
Electrical Circuit Diagram
Electrical Connection for Gas AES Systems
For models using a gas AES system the electrician is required to install a domestic electrical
outlet socket adjacent to the gas heater location. The gas heater requires a 220-240 volt 50 Hz
powersupply and is rated at 0.47 amperes.
All gas work must comply with local regulations including AS5701/AG601 and AS/NZ 3500.4
All gas work must be conducted by a suitability licensed gas fitter.
Installation of the gas heater must be installed in accordance with the installation instructions
supplied with it .
Conergy systems only use approved Gas Heaters.
Particular attention must be given to the gas supply system to ensure the there is a sufficient gas
supply available to the gas heater when operating at full output burner rate.
Approved Gas Heater Models
Gas heater models used with Conergy solar water heater systems must be certified to all local
requirements, be automatic ignition and have full flame modulation.
Gas heaters other than this type must not be used with a Conergy solar water heater. Particularly
fixed pilot and fixed flame models must not be used under any circumstance.
Please refer to your local distributor for information on approved gas heater model.
4.13.2
4.13.3
4.14.1

%
/)# #9#,).'
4(%2-/34!4
%,%-%.4
%!24(
.%542!,
,)6%

,
.
4 Installation Instructions