User Manual

4
FCC Information to user
This product does not contain any user serviceable components
and is to be used with approved antennas only. Any product
changes or modifications will invalidate all applicable regulatory
certifications and approvals.
FCC Electronic Emission Notices
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including
interference that may cause undesired operation.
FCC Radio Frequency Interference statement
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications.
Operation of this equipment in a residential area may cause
harmful interference in which case the user will be required to
correct the interference at his own expense.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
References
For Intersil documents available on the internet, see web site
http://www.intersil.com
or
Intersil AnswerFAX [phone].
[1] TB337 Tech Brief, Intersil Corporation, “A Brief Tutorial on
Spread Spectrum and Packet Radio”, AnswerFAX document
No. 82337.
[2] TB382 Tech Brief, Intersil Corporation, “Measurement of
WLAN Receiver Sensitivity”
[3] AN9850 Application Note, Intersil Corporation,
“Complementary Code Keying Made Simple”
[4] TB395, Tech Brief, Intersil Corporation, “RF Probing of the
ISL37300P and the ISL37300XU”
[5] AN9829 Application Note, Intersil Corporation, “Brief
Tutorial on IEEE 802.11 Wireless LANs”
[6] AN9820 Application Note, Intersil Corporation, “A
Condensed Review of Spread Spectrum Techniques for ISM
Band Systems”
Further information can be found in the following:
• Intersil PRISM 2.5 data sheets, web home page,
http://www.intersil.com/design/prism/ser-p25-11mbps.asp
• IEEE 802.11 Standards Project (available from the IEEE,
New York, USA).
FNXXXX