Installation Manual

Preliminary OEM installation manual
FCC ID: OSZ39000M Page 7 of 10
1.3 Wireless LAN installation guide lines and Authorization for use
Installation and use of this Wireless LAN device must be in strict accordance with the instructions
included in the user documentation provided with the product. Any changes or modifications made to
this device that are not expressly approved by Intersil may void the user’s authority to operate the
equipment. Intersil is not responsible for any radio or television interference caused by unauthorized
modification of this device, or the substitution or attachment of connecting cables and equipment other
than specified. It is the responsibility of the user to correct any interference caused by such
unauthorized modification, substitution or attachment. Intersil and its authorized resellers or
distributors will assume no liability for any damage or violation of government regulations arising from
failing to comply with these guidelines.
The use of Wireless LAN devices may be restricted in some situations or environments for example:
* On board of airplanes, or
* In an explosive environment, or
* In case the interference risk to other devices or services is perceived or identified as harmful.
In case the policy regarding the use of Wireless LAN devices in specific organizations or environments
(e.g. airports, hospitals, chemical/oil/gas industrial plants, private buildings etc.) is not clear, please
first verify authorization to use these devices prior to operating the equipment.
2-Regulatory information
2.1 FCC Information to User
This product does not contain any user serviceable components and is to be used with approved
antennas only. Any product changes or modifications will invalidate all applicable regulatory
certifications and approvals
2.2 FCC Guidelines for Human Exposure
SAR (Specific Absorption Rate) for this device was measured in accordance with FCC OET Bulletin 65
(Supplement C) and guidelines established in IEEE C95.1-1991. Based on these measurements, this device fulfills
the SAR limits for general population / uncontrolled exposure
Caution:
In order to comply with RF exposure limits established in the ANSI C95.1 standards, the user is advised
to maintain a distance of at least 1.0 cm from the antenna of this device while it is in use.
2.3 FCC Electronic Emission Notices
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired
operation.
Caution:
1--Within 5.15 to 5.25 MHz bands, UNII devices are restricted to indoor operations to reduce any potential
harmfull interference to co-channel Mobile Satelite Systems (MSS) operations.
2--High power radars are allocated as primary users in the 5.25 to 5.35GHz and 5.65 to 5.85GHz bands. These
high power radar stations can cause interference with and/or damage to this device.