User Manual

The Anti-Entrapment Barrier is included in this ladder for the U.S. and Canada only, as required by ANSI/APSP requirements.
The Anti-Entrapment Barrier is NOT intended as a substitute for competent adult supervision.
If you would like to purchase the barrier, please visit our website at: www.conferladders.com
MADE IN THE U.S.A. by:
MODEL #6000
ADJUSTABLE HEAVY DUTY INPOOL LADDER
42" TO 56"
ASSEMBLY AND INSTRUCTION MANUAL
SAVE THESE INSTRUCTIONS
DEALER/INSTALLER: GIVE TO HOMEOWNER
IMPORTANT
FOR YOUR SAFETY
* Check the contents of the carton with the Parts list
for this ladder.
* If any parts are missing call Toll Free U.S. -
866-396-2968 or visit our web site at
www.conferladders.com
* DO NOT attempt to assemble or install the ladder
if there are ANY shortages of parts or hardware.
* For proper assembly and installation follow all
instructions in the sequence shown.
* Before using the product, after assembly and
installation, go over the instructions and procedures
again to make sure nothing has been overlooked.
* Be sure and safe. The manufacturer IS NOT
responsible for improper assembly, installation
and use.
SAFETY RULES
* One person on the ladder at a time
* Ladder MUST be installed per manufacturer’s
instructions
* DANGER: No Jumping or Diving from ladder
* Face ladder when entering and leaving pool
* To prevent entrapment or drowning — DO NOT
swim through, behind or around ladder
* Ladder to be used as a swimming pool ladder only.
* Weight limit - 350 lbs maximum
* Warning: Exceeding the maximum weight
restriction may cause the ladder to fail.
* Consult your local Building Department before
installation of your pool and equipment.
* DANGER:
Use a cordless drill for assembly
and installation. NEVER use an electric drill in
or around the pool.
SKIM-IT (SKIMS OFF DEBRIS) - Cut cleaning time 75%
with skimmer extension that guides debris directly into your
skimmer. Fits most in-ground and above-ground pool skim-
mers. Corrosion-resistant plastic Skim-It installs in seconds
without tools.
# 6000 Extension Kit (Part # 6000-EXT) - Raises ladder to
reach deck heights from 57” to approximately 68”. Kit
includes two extension boots, one additional ladder tread,
hardware and instructions.
ADDITIONAL ACCESSORIES MAY BE PURCHASED
Order online at www.conferladders.com
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 1-800-635-3213
716-694-3100
www.conferladders.com
Printed in U.S.A. CP-6000 8/13
MADE IN THE U.S.A. by:
4
CONFER PLASTICS, INC.
LIMITED, PRO-RATED WARRANTY
Confer Plastics, Inc. warrants their swimming pool ladders to be free from defects in workmanship for one year from
date of purchase. After the first year the cost to replace a part is as follows:
MODEL #6000B
2
nd
Year - 20%
3
rd
Year - 40%
4
th
Year - 60%
5
th
Year - 80%
Plus shipping/handling
Enclose proof-of-purchase (receipts, etc.) showing date purchased, your name, address, and daytime phone number. You
will be notified of cost to replace part.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
DO NOT RETURN DEFECTIVE PART TO DEALER
The defective part should be returned, postpaid, to:
Confer Plastics, Inc.
97 Witmer Road
North Tonawanda, N.Y. 14120-2421
of current parts
list price
Confer 6000-8/13:Confer 6000_R1 8/8/13 9:57 AM Page 1