Installation Instructions

7
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
2000 Series (HP) Dual Pole Connector
Note: Check all bolts every three months or as needed to insure all connector
.denetsaf yleruces si erawdrah
Tighten all bolts in the dock using
25 lbs/ft (3.46 kg/m) of torque.
Anchor as desired.
NOTE: DO NOT SUBMERGE...
a minimum of 2 (5.08 cm) must
show above the water surface
for venting purposes.
Place the Dual Pole Connector over
the Float Connectors, then push down
on Dual Pole Conntor to hold in place.
Secure with bolts, washers, and
bushings as in Step 1.
Hardware Included
Tools Needed Instructions for:
Dual Pole Conector (DPC2023)
9/16“ (16 mm) Socket wrench
Step 1
Install two Float Connectors into
Float Section sockets where the
Dual Pole Connector will be attached.
Secure Float Connectors into sockets
with bolts, washers, and bushings as
shown (Hand tighten only).
Step 2
Step 3
3/8 x 1-1/4 (10 mm x 35 mm)
Hex bolts
Diamond washers
Bushings
Align Dual Pole
Connector with Float
Connectors
1
Float Connector
2
3