Installation Instructions

11
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
2000 Series Utility Channel End Cap
Instructions for:
Utility Channel (UT2024),
(UT2048), (UTC2048)
Tools Needed
Drill - 1/8” (3 mm) drill bit
Awl
Phillips Screw driver
Step 1
Place End Cap into the Utility
Channel with wide side at the top.
End Cap placed on male end chaffer
side out and female end chaffer side
in. Use an awl to mark hole
locations. Remove End Cap.
Step 2
Drill the holes with 1/8” (3 mm) bit.
Step 3
Place End Cap back into the Utility
Channel. Then coat the Truss head
screws with some silicon. Hand
tighten the screws. (Don’t over
tighten will strip the holes).
1
2
3
Materials Needed
4- #8 Truss head 3/4”(4.2mm x 1.4mm
x 20mm) (Stainless Steel)
Silcon
Note: The bottom two Screws are optional, if the lid will be removed frequently.