Installation Instructions

36
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
Deep Water Hardware
Instructions for:
Deep Water Hardware (DW1010)
Step 1
Thread two 1/2” nuts down about
1-1/4” on each eye bolt and tighten
them against each other.
Hardware Included
(2) 12” Eye bolts
(2) Diamond washers
(2) 1/2” Washers
(4) 1/2” Hex nuts
(2) 1/2” Acorn nuts
Step 2
Place 12” eye bolts on opposite
sides of platform or dock
system. Add one 1/2” washer
and insert eye bolt as shown.
Step 3
Place washer and acorn nut
on eye bolt and tighten.
Attach your anchoring system
to the eye bolts.
Tools Needed
2-3/4” Wrench
Not available in metric
3
Suggested Method
Note: Check all bolts every three months or as needed to insure all connector
hardware is securely fastened.
1
1-1/4”
2
Location of 12” Eye Bolts