User's Manual

Nano WiReach SMT G2 –Datasheet

Appendix B – AT+I Configuration Examples

Automatically connect to a specific Access Point:

AT+iFD (restore to factory defaults)

AT+iHIF=1 (set the serial interface to RS232)

AT+iBDRF=9 (fix baud rate to 115200 after power cycle)

AT+iRP20 (list visible networks)

AT+iWLSI=My_WiFi

AT+iWST0=4 (WPA2 security)

AT+iWPP0=<WPA2 passphrase>

AT+iAWS=1 (enable website upon reboot)

AT+iDOWN (reboot to apply settings)

Create an Access Point to allow connection from mobile devices:

AT+iFD (restore to factory defaults)

AT+iHIF=1 (set the serial interface to RS232)

AT+iBDRF=9 (fix baud rate to 115200 after power cycle)

AT+iWLSI=My_AP

AT+iDIP=10.0.0.1 (IP address)

AT+iDPSZ=8 (Enable internal DHCP server, up to 8 clients)

AT+iWST0=0 (open security)

AT+iAWS=1 (enable website upon reboot)

AT+iDOWN (reboot to apply settings)

LAN – WiFi switch mode - merges Ethernet station(s) with WiFi client(s) into one logical subnet

AT+iFD (restore to factory defaults)

AT+iHIF=1 (set the serial interface to RS232)

AT+iBDRF=9 (fix baud rate to 115200 after power cycle)

AT+iwlsi=SWITCH

AT+idpsz=8 (Enable internal DHCP server, up to 8 clients)

AT+iwst0=0 (open security)

AT+iltyp=4 (LAN type: WiFi+Ethernet)

AT+idip=192.168.0.1 (WiFi side IP address)

AT+isnet=255.255.255.0 (WiFi side subnet mask)