Specifications

Page 15
Cycle power or jump RESET terminal to COMMON.
The processor now recognizes the program switch
change.
Cycle power or jump RESET terminal to COMMON.
The processor now clears the preset program and
substitutes the default parameters. (See Table 1.)
SWITCHING BETWEEN PROGRAMS
When changing from one preset program to another remember —
Reset the Processor
TROUBLESHOOTING
RELOADING DEFAULT CONDITIONS
If a system that includes a CS-5000 Series control suddenly acts up, the rst task is to isolating the fault.
Is it a:
Processor or Program glitch,
Motor Control failure,
Ground fault, or
failed Coiltek Control.
A simple procedure clears any of the Program addresses #0
to #7 and substitutes default conditions. To reload defaults,
select the program you wish to clear using the three PreSet
switches. Set all four Range switches plus the TEST switch
ON. position.
Then
Reset the Processor