Specifications

Page 4
DESIGN
COILTEK CS-5000 Series controls operate on 120
or 240-volt ac current. Properly enclosed, it will give
years of reliable service in normal industrial environ-
ments. Both CS-5000 and CS-5100 controls come
with a NEMA-12 enclosure.
Auto ranging and easy-to-understand switch settings
simplify setup. To prevent unauthorized changes,
setup controls are on the circuit board inside an
enclosure. No external adjustments are available to
unauthorized personnel.
For special setup and gaging applications, CS-5000
Series controls connect to any IBM-compatible com-
puter through a standard DB-9 RS-232C Serial Port
cable. Menu-driven CSWIN32 software gives access
to all of the many control parameters and functions.
The computer can remain interactive with the control
while the system is on line. You can observe the effect
of changes on operation, ne tune the system, then
remove the computer interface. The control retains all
program parameters in memory. The control stores up
to 8 separate control programs. You can also select
from three programs from a remote switch location.
The control is microprocessor based and will not
drift. Periodic adjustments are not necessary after
initial setup. Changeable control parameters are held in a non-volatile memory chip. The stated memory
retention of this device is ten years.
The ultrasonic sensor is rugged and protected by a grid. However, some care is necessary.
Do not:
Allow uids to contact it.
Paint over it.
Puncture it.
Expose it to temperatures over 180
o
F.