Users Manual

Page | 12
ITEMS REQUIRED FOR INSTALLATION
i
NOTE
The following tools are needed to install the ConnectDER:
1. A torque wrench and/or torque screwdriver to cover a range from 2 to 50 in/lbs.
2. A #2 Philips screwdriver bit for use with torque wrench/screwdriver.
3. A ¼” flat screwdriver bit for use with the torque wrench/screwdriver.
4. A pair of wire cutters.
5. A wire stripper.
6. Suitable metering equipment such as a digital volt-ohmmeter.
Other items needed:
• Tools to attach the raceway to ConnectDER junction box and terminate field wiring.
• An approved wiring connector to terminate the neutral pigtail inside the meter
socket, if applicable.
• An additional meter locking ring (for ring-type meter sockets).
• Additional utility tamper-prevention seals.
At a minimum, the installer should use the following safety personal protective equipment
(PPE):
1. A flash shield.
2. Safety glasses.
3. A pair of rubber gloves.
4. A pair of leather gloves.
5. Calorie rated clothing.
Other equipment may be required by utility procedures. These requirements will be
communicated to the installer by their employer during the training process.
METER REMOVAL
WARNING
In most service territories, meter removal will be a utility function. Contact your
utility for specific information on their standard practices and/or to schedule a visit by
utility or utility approved personnel to remove the meter. If power is not removed from
the equipment prior to working inside the meter socket, electric shock, arc flash hazards,
fire, serious injury or death may result.