User's Manual

© 2016 Connected Holdings LLC 13 / 20
Periodic Action Commands (with Events)
Periodic Action commands trigger time based periodic action, such as reset, data session
renewal, etc. Some actions can trigger an event report to indicate the respective action took
place. Following is a list of event setting commands:
41. AT+XCFC CDMA FOTA Configuration (CDMA devices only)
42. AT+XCPC CDMA PRL Configuration (CDMA devices only)
43. AT+XDNSP DNS renew Periodically
44. AT+XKA Keep Alive
45. AT+XPST Packet Session Timeout
46. AT+XRSTP Reset Periodically
Configuration Commands
Configuration commands control various parameter settings of the device. For convenience
they are grouped into topical settings. Following is a list of configuration commands:
Communication related settings
47. AT+XAPN Set APN (GSM devices only)
48. AT+XCSW Cellular Session Watchdog
49. AT+XIP Set target server IP address and port number
50. AT+XLPORT Set Local IP port number
51. AT+XMIP Set Maintenance server IP address and port number
52. AT+XPRP PxP Renewal Policy
53. AT+XSMSD SMS Destination
54. AT+XSMSS SMS Source
55. AT+XSPIP Set Serial Port (A-UART) IP address and port number
56. AT+XUIP Set Update server IP address and port number
Protocol related settings
57. AT+XRPA Report Acknowledge
58. AT+XRPF Report Format – Protocol, ASCII/Binary
59. AT+XRPM Report Mask
60. AT+XRPQ Report Queue length
61. AT+XRPSF Report Start Frame
Drive Trip related settings
62. AT+XDDI Drive Distance Interval
63. AT+XDHC Drive Heading Change
64. AT+XDMES Drive Motion End Speed
65. AT+XDMSD Drive Motion start Distance
66. AT+XDMSS Drive Motion Start speed
67. AT+XDMT Drive Motion Trigger
68. AT+XDTT Drive Trip Trigger
Peripheral related settings