CIO Router: CR48NA User Manual Revision: 1.3 CIO Router: CR48NA User Manual Rev: V1.
CIO Router: CR48NA User Manual Revision: 1.3 Revision History: Date Rev No. Description By 11-Feb-19 R1.0 Initial Release Connected IO 25-Feb-19 R1.1 Add 5G statement in p.23 Connected IO 04-Mar-19 R1.2 Modify minimum distance of 31cm between the radiator and the human body. Add Antenna information into p.24 Connected IO 05-Mar-19 R1.
CIO Router: CR48NA User Manual Revision: 1.3 Table of Contents 1. INTRODUCTION 5 2. Hardware Configuration 5 2.1. Product Interfaces 5 2.2. Radio Configurations 7 3. System Configuration 7 3.1. Initial IP Setup 7 3.2. Setup WAN protocol 9 3.3. Setup LAN IP 9 3.4. Setup Wi-Fi 10 3.4.1. Setup Wi-Fi network 10 3.4.2. Connecting to the Wi-Fi 11 4. Firewall 13 4.1. WAN Ping Respond 13 4.2. Port Forwards 13 4.3. IP Filtering 14 4.4. MAC Filtering 14 4.5.
CIO Router: CR48NA User Manual Revision: 1.3 6.2. APN Change 19 6.3. Unlock PIN protection 19 6.4. Authentication 19 6.5. Modem Firmware 20 6.6. SIM slot 20 7. LOGS 7.1. 8. 20 System LOG 20 Antenna 21 8.1. Detachable Antennas 21 8.2. Antenna – Installation Guidelines 21 8.2.1. 8. Instructions d’installation Professionnelle Environmental 21 22 8.1. Operating Environment 22 8.2. Physical Parameters 22 9. Approvals and Certifications 22 9.1. Manufacturing 22 9.2.
CIO Router: CR48NA User Manual Revision: 1.3 1. Introduction Connected IO’s CR48NA router (“The Router“) is a 4G router offering CAT4 connectivity. The Router includes a 4G modem with an embedded host processor based on Qualcomm Dakota SoC which also supports 802.11 b/g/n/ac Wi-Fi functionality. The 4G connectivity is made by an operator certified LTE module. This document provides instructions, and basic operational guidelines, to aid a Systems Administrator with the deployment of this product. 2.
CIO Router: CR48NA User Manual Revision: 1.3 Number Item 5 LAN Port 6 WAN Port Description LAN Port for Wired Ethernet Clients LED: Solid Green for Link, Flashing Green for Traffic WAN Port for establishing links to leased telecommunication circuits LED: Solid Green for Link, Flashing Green for Traffic 2FF Mini-SIM format 7 SIM Access Slide the door open to access the SIM holder.
CIO Router: CR48NA User Manual Revision: 1.
CIO Router: CR48NA User Manual Revision: 1.3 Figure 1: Login Page The Router overview is available after logging into the GUI, the overview page includes important messages such as system status and memory information as shown in Figure 2.
CIO Router: CR48NA User Manual Revision: 1.3 3.2. Setup WAN protocol Select to Network -> WAN to configure WAN protocol as shown in Figure 3. Figure 3: WAN protocol Click SWITCH PROTOCOL button to after select in Protocol. Then, it needs to input WAN IP address when you select to Static address, or input server settings when you select to PPPoE PPTP and L2TP. For WWAN, please refer to chapter 6. 3.3. Setup LAN IP Select Network->LAN as shown in Figure 4.
CIO Router: CR48NA User Manual Revision: 1.3 Figure 5: Save the New Setting 3.4. Setup Wi-Fi 3.4.1. Setup Wi-Fi network Select to Network -> Wireless 2.4GHz and Network -> Wireless 5GHz to configure Wi-Fi network name, channel and encryption settings of your 2.4GHz and 5GHz respectively. To configure Wi-Fi network name and channel, you can enter the name into SSID field and select channel in Operating frequency as shown in Figure 6.
CIO Router: CR48NA User Manual Revision: 1.3 By default, there is no encryption on Wi-Fi interfaces. It is strong suggested to enable encryption by switch to Wireless Security and enable it by select in Encryption, Cipher and input Key as shown in Figure 7. Figure 7: Wi-Fi security After the Wi-Fi setup, scroll down to the bottom of the page and press “APPLY” as shown in Figure 6. 3.4.2.
CIO Router: CR48NA User Manual Revision: 1.3 Figure 8: Network Internet Access Open a browser and typing http://192.168.71.1 to login into the GUI again. Once the GUI is up the user should see the EMU Router overview with Wi-Fi Connection information as shown in Figure 9, Wireless Information.
CIO Router: CR48NA User Manual Revision: 1.3 4. Firewall 4.1. WAN Ping Respond Select to Network -> Firewall -> General Settings to enable/disable WAN Ping Respond as shown in Figure 10. Disable WAN Ping Respond is able to prevent the WAN port interfaces from responding to ping/ICMP requests. Figure 10: WAN ping response 4.2.
CIO Router: CR48NA User Manual Revision: 1.3 4.3. IP Filtering Select to Network -> Firewall -> IP Filtering as shown in Figure 12 to restrict access to the Internet to specific IP addresses on your LAN network. Figure 12: IP Filtering 4.4. MAC Filtering Select to Network -> Firewall -> MAC Filtering as shown in Figure 13 to restrict access to the Internet to specific IP addresses on your LAN network.
CIO Router: CR48NA User Manual Revision: 1.3 4.5. Dos Prevention Select to Network -> Firewall -> Dos Prevention as shown in Figure 14 to against common denial of service (DoS) attacks. Dos attacks are achieved by flooding a specific network resource by excessively sending unnecessary requests which can cause the network device or resource to stop functioning. Figure 14: DoS Prevention 4.6.
CIO Router: CR48NA User Manual Revision: 1.3 5. System Maintenance This chapter describes how to back-up the current The Router configuration to your computer, and how to restore that same configuration later if needed. This can be done by selecting Administrator > Backup / Flash Firmware as show in Figure 16 Figure 16: Backup/Restore the Configuration 5.1.
CIO Router: CR48NA User Manual Revision: 1.3 5.3. Reset to Factory Default under Web GUI Click the icon “Perform reset” in the GUI page as shown in Figure 16, a warning window will pop-up saying, “Really reset all changes?” as shown in Figure 16. The device will reset to factory default and reboot if “Yes” is chosen. NOTE: It is important NOT to power off the device before the entire process is completed. Figure 16: Reset to Default 5.4.
CIO Router: CR48NA User Manual Revision: 1.3 Figure 17: Firmware Upgrade 6. WWan Select Network -> WAN as shown in Figure 18. Select Protocol to WWan. Then click the icon “SWITCH PROTOCOL” Figure 18: WAN Page 6.1. Auto Connect Auto Connect option as shown in Figure 19, allow you to decide whether device automatic connect to carrier when disconnection, or only connect once you would like it to connect.
CIO Router: CR48NA User Manual Revision: 1.3 Figure 19: WWan page 6.2. APN Change The APN Change field allows you to change the local telecommunication company. Enter the APN name and click “APPLY” button as shown in Figure 19. 6.3. Unlock PIN protection If your SIM card is protected by PIN code, you must input your PIN in PIN field as shown in Figure 19 before your device is able to connect to carrier. 6.4.
CIO Router: CR48NA User Manual Revision: 1.3 6.5. Modem Firmware CR48NA supports Verizon, AT&T, T-Mobile and service providers in Canada (Refer to “9.2. North American Certifications”) in single sku. Select to proper modem firmware as shown in Figure 19 per your carrier. 6.6. SIM slot CR48NA support two SIM slot. If only one SIM slot inserted SIM card, device will automatic detect and select to it.
CIO Router: CR48NA User Manual Revision: 1.3 8. Antenna 8.1. Detachable Antennas This LTE Router device, CR48NA integrates LTE (4G) and Wi-Fi radio function. Detachable Antenna Guidelines This equipment complies with the FCC and IC radiation exposure limits set forth for an uncontrolled environment. While EUT operates for Wi-Fi 2.4G/5G and UMTS concurrently, the antenna should be installed and operated with a minimum distance of 31cm between the radiator and the human body 8.2.
CIO Router: CR48NA User Manual Revision: 1.3 Utiliser uniiquement les antennes approuvees par le fabricant. L'utilisation d'autres antennes peut conduire a un niveau de rayonnement essentiel ou non essentiel depassant les niveaux limites definis par FCC/ISED, ce qui est interdit. 4. Procedure d'installation Consulter le manuel d'utilisation. 4. Avertissement Choisir avec soin la position d'installation et s'assurer que la puissance de sortie ne depasse pas les limites en vigueur.
CIO Router: CR48NA User Manual Revision: 1.3 o This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. • • Canada o CAN ICES-3 (B) / NMB-3 (B) o This device Complies with ICES-003:2016 Issue 6, Class B.
CIO Router: CR48NA User Manual Revision: 1.3 RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 23cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
CIO Router: CR48NA User Manual Revision: 1.3 (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Radio Frequency (RF) Exposure Information The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits.
CIO Router: CR48NA User Manual Revision: 1.3 1 2 3 Joymax YWX-6252SAXX711 Microstrip Joymax TWX-6141RSXX711 Microstrip Joymax TWX-1513RSXX711 Collinear LTE: 698-960MHz/ 1710-2170MHz/ 2500-2960MHz 3dBi Max Wi-Fi: 2400~2500MHz: 3.0dBi 5000~5900MHz: 5.0dBi Wi-Fi: 2400~2500MHz: 5.0dBi 5000~5900MHz: 5.
