User's Manual

Connected IO,
C
ON
F
I
D
E
N
T
I
A
L
17
CIO Router: CR48NA User Manual
Revision: 1.3
5.3. Reset to Factory Default under Web GUI
Click the icon “Perform reset” in the GUI page as shown in Figure 16, a warning window will pop-up
saying, “Really reset all changes?” as shown in
Figure 16. The device will reset to factory default and reboot if “Yes” is chosen.
NOTE: It is important NOT to power off the device before the entire process is completed.
Figure 16: Reset to Default
5.4. Firmware Upgrade
Select Administrator from web GUI and find “Backup/Flash Firmware” section as shown Figure 16.
Click the icon “Choose File” and select the new image that you want upgraded to the device, then click
“Flash image”. After system uploads the file, click “Proceed” on the confirmation page as shown in
Figure 17.
The upgrade process may take longer than 10 minutes for flashing and rebooting. It is important NOT to
power off the device during the process. Administrators can PING the device after the upgrade process is
completed to ensure that the device is programmed and rebooted successfully.