User Manual

Dongle User’Guide Aug02/BtrekRefV1/GpoV1
4. Dongle status and LED indication
The dongle was designed to be very easy to use for a daily use. But it is important to
understand how to configurate this device before you use it. So please read carefully the
information just below :
4.1. The dongle can have four modes :
4.1.1. Switch off
This mode is very simple to recognise because the LED is always off. When you are in
one of the mode 2,3 or 4 please press 2 to 3 seconds until you see green and red LED
together. Then you relaese the button and the LED becomes off.
4.1.2. Standby mode
The dongle is in this mode when the green LED (or red when the battery is low) is
flashing slowly. Be carefull because the flash is short every 7 seconds.
To go in standby mode be sure first your dongle is switched off. Then press the button
for aroud 3 seconds until you see the led on then release the button. You will see the red
LED on and quick flashes of the green LED. The number of green flashes indicates the
profile number which is programmed. Then the green LED (or red if the battery is low)
will flash slowly.
4.1.3. Pairing mode
The dongle is in this mode when you can see an alternating very quick flash of the red
and green LED.
To go to pairing mode be sure first your dongle is switched off. Then press the button for
around 10 seconds until you see aternating quick red and green flashes. Actually to go to
pairing mode you go first in standby mode (don’t release the button) then the LED
switches off for around 1 second (you still have to keep pressed the button) and just
after you will see the quick flashes. You can now release the button.
4.1.4. Profiles mode
This mode was created for the first time in the world by Innovi. This mode allows you to
have only one device, your dongle, able to work with almost all non Bluetooth mobile
phone on the market. By choosing the mode according to your mobile phone (see
appendix) the electronic adapts automatically the signals to the dedicated cable provided
with the dongle. The programmation of the profile has to be done only once when you
have a new phone or when you change it. Each phone has a profile. Sometimes this is
the same so you don’t need to reprogram it.
Page 7 of 16
Innovi Technologies Ltd
Suite 501-3, 5/F, Chinachem Leighton Plaza, 29 Leighton Road, Causeway Bay, Hong Kong
Tel: [phone], Fax: [phone]
Email: [e-mail]
, Web: www.innovi.com