User`s manual

SIERRA VIDEO

Connecting To Video Devices

Video sources and output devices (such as monitors, or recorders) may be connected to the

routing switchers through the BNC type connectors located on the back of the unit. Keep in mind

that the output signal format will be that of the input signal format.

All signal connections that use more than one cable interconnecting between devices should be

of equal timing length (example: cables between a camera and the switcher should have the

same time delay).

The rear panel of the frame is laid out in the most logical fashion possible. The individual

channels are color-coded. The white and yellow conventions, used for the H and V sync

channels, are arbitrary and these two channels are interchangeable. Each channel can have only

“H” or “V” signals – not both. All inputs are factory set for 75 ohm termination. The sync (“H” “V”)

input terminations can be changed to 510 ohm by changing the dip switches located on the rear

panel of the router. The upper row of switches applies to the “white” row of inputs with the lower

row of switches applying to the “yellow” row. Unused outputs do not need to be terminated.

Connecting To Audio Devices

Audio sources and output devices (such as amplifiers or recorders) are connected to the

switchers through the terminal block connectors located at, and marked, on the rear of the

switcher.

1616V5S Terminal block connectors

Rear panel DIP

Switches

Upper DIP

Switch

Lower DIP

Switch