User Manual

Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
18
CONNEX ProSight Installation and Operation Guide
Installing the Units|Connecting Components to Drone
Navigation pane
2. Place the antenna on the rear side of the drone mounting plate.
Home Page
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
Configuration Using
ProSight Desktop
Application
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
3. Fasten the antenna base to the drone with four screws (1) using
washers (2) and nuts (3).
B- Connecting Antenna to HD Transmitter
1. Route the antenna cables from the base of the antenna holder to
the HD transmitter (3).
2. Connect the two HD Transmitter Antennas (1) to the coax sockets
1
(2).
2
3
3. Secure the antenna cables.
Note:
Be sure the antenna cable loop is maintained. The cable’s minimum
bend radius is 5mm.
Tip:
The antenna can be connected to the drone using zip ties instead of
screws.
1
2
3